— 177 —
in Upper Bavaria, for all around it is enclosed by high, sharply rising mountains. In the north we have the plain of Gennesaret, which was formerly irrigated from the springs not far from Capernaum by a channel hewn in the rock. This low plain is framed by high-rising mountains, and is flowed through by two small streamlets, which in summer dry up entirely, but in the rainy season often swell so that a part of the plain disappears beneath them. The aforementioned aqueduct channel had a depth of 0.6 m with a breadth of 1.2 m.
The springs which fed this channel lie deeper than the channel, and in order to bring the water up, the smaller spring was enclosed with a vertically rising tube of squared stone blocks of about 40 cm diameter, parts of which are still in existence to-day. A larger spring furnishes water for a bathing establishment, and this spring is enclosed by a masonry casing in octagon form, 6 m in diameter.
The remains of the walls of these spring-casings still rise at present 10 m above the level of the lake, and in earlier times the water must after all have been driven 15 to 20 m high, in order to flow in the channel to the northern slope of the plain of Gennesaret. From this slope the whole plain could then be irrigated without great difficulty.
Not only the works of an old irrigation do we find there, but an old mill also affords a splendid, romantic sight. Several masonry arches, namely, carry a water channel which discharges into a vertically standing masonry pipe. Below, the pipe possesses an opening at the side, so that the water spurts out horizontally with great force. The height of fall is about 5 m. Now one would surely suppose that for the utilization of this water-power a simple water-wheel, such as were known even in the most ancient times, would have been used. I was, however, astonished in the highest degree when I found a tangential wheel — that is, a partially admitted turbine — of 1.4 m diameter, with 18 radially set straight wooden blades 25 cm broad, which were keyed into a wooden hub 50 cm in length and 40 cm in diameter. The vertically standing turbine shaft had a thickness of 15 cm with a length of 4.5 m, and was made of hardwood. This turbine served for the driving of a mill. The
